ASTEL LIGHTING METEOR LSR0640EQ Series, Руководство по эксплуатации

Страница: 5 / 12

5
INSTALLATION
The underwater light kit consists of the following components:
• Underwater Light METEOR LSR0640EQ
• 4 x fixing screw 5.5x50 with wallplugs
• Operating Instructions with Declaration of Conformity and Warranty conditions
The METEOR LSR0640EQ has to be installed on a flat surface on the pool wall under water line.
Do not try to install the underwater pool light while the pool is filled with water.
When the installation is finished briefly test the underwater light prior to fill the pool with water.
The installation have to be realized by a qualified personnel.
SEALING GROOVE
SCREW 5.5X50
SEALING
Note:
• Avoid using the underwater pool light out of the water – submerge before lighting.
Wall preparation
To fix the underwater pool light with screws 5.5x50 the diameter of holes drilled into the wall has to
be 8mm.
The diameter of the hole for cable gland drilled through the wall has to be 10mm.
Sealing
Before inserting the cable with gland through the hole the sealant has to be used into the grooves,
around the four fixing holes and around the gland in the rear surface of the underwater pool light.
The sealant can be on silicon basis but the best solution is MS polymer sealant.
Fixing
The underwater light has to be fixed with four screws 5.5x50 with wallplugs.
Note:
• Do not overtighten the screws as this can result in underwater pool light damage.
Earthing
The underwater pool light has to be earthed by using a pre-tinned green wire with a yellow stripe a
minimum of 8 AWG (8.36 mm
2
). The wire has to be connected to the underwater pool light by the
help of one fixing screw 5.5x50.