ASTEC PHOENIX Talon, Руководство по эксплуатации и обслуживанию

Страница: 21 / 31

PHOENIX Talon - Operation and Service Manual
21
j.
They can even cause pipes to burst causing damage and possible injury.
k. Set the oil heater temperature regulator, and the indicating low oil temperature switch (located on
the burner’s oil manifold) to the temperature determined in item 2b above.
l.
This will prevent the burner from operating when the oil is too thick to be atomized and burn well,
and will prevent damage to your plant.
3.
For the pipe sizes recommended for heavy oil, see Table
– 8 in the previous section.
4.
Purge the lines before attaching them to the fuel manifold.
5.
Adjust the pressure relief valve until the required oil pressure is attained.
6.
See the individual burner performance sheets for approximate valve settings.
7. Final pump pressure will have to be adjusted to attain desired burner output, depending on system
design.
8.
The burner oil flow control (metering) valve range is usually set from Position 0 to Position 12. (must
see individual performance sheets)
9.
The high fire oil flow can be set by varying the fuel pressure, or by changing the valve profile in the
control system.
10.
Do not change the linkage settings. (See the individual burner performance sheets for proper fuel
flows.)
11.
The manual low fire bypass oil control valve is used to set and maintain the low fire oil flow at the
burner.
12. See the individual burner performance sheets for the low fire oil setting.
13.
The low oil pressure switch is factory set at 30 PSIG.
WARNING!

These settings are for the initial set-up only.

Final settings will have to be adjusted for the particular operating conditions.

Be sure not to have more fuel flow than there is combustion air available, or "puffing" and a
dangerously rich firing condition could occur.