ASTEC Peterson 6700B, Руководство по безопасности оператора

Страница: 70 / 152

C
H A P T E R
3 O
P E R A T I N G T H E
6 7 0 0 B
6 8 6 7 0 0 B G
R I N D E R
O
P E R A T O R
S
A F E T Y
M
A N U A L
8 1 7 8 5 C
Setting Up for Operation
◆
Setting up the machine involves the
following steps:
1. Unfold the ladder.
2. Raise or lower the tailgate (if installed).
3. Unroll the debris curtain.
4. Connect the water sprinkler to a source.
5. Inflate the air bags (if installed).
6. Start the engine.
7. Set the slide gate.
8. Unfold the discharge conveyor.
These steps are described in this section.
Unfold the Ladder
For travel and storage, the folding ladder (Figure 102) is
held in an upright position next to the walkway.
◆
To use the ladder:
1. Remove the transport pin.
2. Pull the ladder toward you to move it to the operat-
ing position.
3. Use the hand holds to safely climb on or off the
machine.
When you are ready to travel or you want to leave the
6700B unattended, lift the ladder to its upright position
and lock it in place.
Figure 102: Transport Pin on the Folding Ladder
Raise or Lower the Tailgate
If your machine is equipped with a tailgate, lower or
raise it at this time. Be careful. The tailgate can be diffi-
cult to handle for one person.
1
CAUTION
Get help or use care in raising or lowering the
heavy tailgate. Always let tailgate down slowly.
Be careful not to pinch fingers or hurt your back.
Unroll the Material Deflector
The material deflector (or debris curtain) is an important
safety feature. Unroll it before operating the machine.
For transport, roll and tie or strap the curtain to prevent
wind drag or damage (Figure 103).
Figure 103: Material Deflector
F05913
F05450