Associated Electrics ProLite 4x4 7052, Руководство пользователя

Страница: 8 / 30

8
:: Wiring Diagrams
:: Wiring Diagrams - (cont.)
Motor and Receiver Wiring:
1. If motor runs in reverse when you apply throttle,
unplug any two of the motor wires and switch them.
2. Your Receiver has multiple channel ports for plugs.
Channel 1 - you should always plug your steering
servo into this channel port.
Channel 2 - you should always plug your speed
control (ESC) into this channel port.
Channel 3 - Used for optional equipment such as
fans, lights, ect...
Batt - Used for optional receiver battery pack.
Not used in this model.
Negative black wires on steering servo and speed control
plugs should face the outside edge of receiver where
channel markers are located.
:: Wiring Diagrams
Receiver Box Gasket Maintenance:
1. Apply a small amount of “hobby grade” glue (not included) to the top edge of
the receiver box in order to hold the receiver box gasket in place.
Do the same for the receiver box lid. Make sure not to get glue on the side
of the gaskets that will make contact with each other!
Wait untill the glue has completely dried
before moving on to the next step!
2. Once the receiver box gasket is installed,
you can then plug your servo and speed
control into your receiver. You can also
run your receiver’s antenna wire into the
antenna tube. Once this is done, you can
now install the radio box lid. The gasket
attached to the receiver box and the
gasket attached to the receiver box lid
will squeeze against the servo, speed
control, and antenna wires.
1
2
1 2