Associated Electrics ProLite 4x4 7052, Руководство пользователя

Страница: 6 / 30

6
:: Quick Start Guide - (cont.)
:: Quick Start Guide - (cont.)
Battery Notes and Tip:
Plug the battery in as shown. Unplug battery when not in use!
There are two types of batteries you can use with this vehicle.
NiMH (nickel-metal hydride) and LiPo (lithium polymer).
LiPo: LiPo batteries (lithium polymer) are high current
rechargeable batteries. LiPo batteries offer extended run time
and peak performance over NiMH batteries. They require a
peak detection charger designed specifically for LiPo batteries.
LiPo/LiFe Charger: (Part # 604 - Reedy 526-S AC/DC 2S-6S
Cell LiPo/LiFe Balance Charger)
These batteries require specal care and handling.
LiPo batteries are recommended for advanced users only!
ALWAYS charge a LiPo battery in LiPo mode.
CAUTION! If using a LiPo battery, you need to change the speed
control settings to LiPo mode (see page 17 for instructions).
If using a 3S LiPo battery, you must use a smaller pinion gear
(use part #91164 13T Pinion). This will give you the correct gear
ratio for the extra power the 3S LiPo
battery will deliver.
Change the speed control to NiMH or LiPo battery modes.
*NOTE: The Transmitter & ESC come Pre-Programmed!
1) Make sure both TH. ATV (LO & HI) is set on your transmitter
all the way to the right or at 100% before you start.
2) Turn on the transmitter.
3) Pull trigger to full throttle and hold it.
4) Turn on the speed control. You will hear six beeps (bibibibibibi)
and see six flashing green lights.
5) Release trigger back to neutral. You will hear two sets of two
beeps (bibi-bibi) and see four flashing green lights.
6) Push trigger to full brakes/reverse. You will hear two sets of
two beeps (bibi-bibi) and see four flashing green lights.
7) Release trigger back to the neutral position.
You will see a red static light.
Wait a few seconds and you will hear audio tones.
8) For NiMH Battery you will hear 1 tone, a pause, then 1 tone
pull and release trigger to select this mode. You will hear two
sets of two beeps (bibi-bibi) and see four flashing green lights.
Now the speed control is in NiMH (nickel metal mode).
If this is your desired setting, turn off your speed control and radio!
If not, do not select this mode and continue to step #9.
9) For Lipo Battery you will hear 1 tone, a pause, then 2 tones
pull and release trigger. You will hear two sets of two beeps
(bibi-bibi) and see four flashing green lights.
Now the speed control is in LiPo mode (lithium polymer mode)
10) If this is your desired setting, turn off your speed
control and radio! If you would like to change the
Drag Brake, Throttle Profile, and Run Mode, see page 17
for the rest of the Speed Control setup sequence.
1
Neutral
Push for
Brake
Pull for Throttle
Throttle set to Neutral when turning on the radio !