BAG H
REMOVE THESE
PARTS FOR:
Steps 1-2
6285, qty 2
4-40 x 1/4
1:1
INSTALLING THE BATTERY PACK
Install the three #9235 foam battery pads.
Install the four #9238 foam battery spacers. (The tuning section will show you how to
adjust your steering or traction by moving these spacers.)
Install your battery pack. (See section at right if you need to assemble it first.)
Thread on the #6929 screw. Aim the body clip hole across the chassis. Add the #7333
(7334*) battery hold down strap. Adjust the screw so the batteries are held tight, but
you are still able to push the #6332 body clip through the screw.
9247, qty 1
gear cover
9247, qty 1
button
9235, qty 1
foam battery pads
9238, qty 4
battery spacer
6929, qty 1
4-40 x 3/8
1:1
7333, 7334*, qty 1
battery hold down strap
6332, qty 1
body clip
SOLDERING INDIVIDUAL CELLS
Solder connections properly to assemble a
battery pack from individual cells.
TIP:
Team racers prefer battery bars or braid
for sturdier connections. Insulated wire will
not allow the pack to fit in the battery slot.
solder connections
with battery bars
or braid
BATTERY PRODUCTS ARE
NOT INCLUDED IN KIT
TOOLS USED
21
3/32"
step 1
LEFT SIDE
9238
9235
hook into rear shock
tower as shown
9238
9238
9238
6929
6332
7333,
7334*
RADIO RECEIVER TO CHASSIS
Cut a piece of servo tape, remove the paper from one side, and attach it to the bottom of your receiver.
Slip the receiver wire through the built-in chassis antenna mount.
Remove the paper from the other side and attach to the chassis as shown.
Plug the small #6747 BEC plug (of step 7) into the receiver's on/off switch.
Follow the instructions that accompany your radio receiver system.
step 9
LEFT SIDE
5
