SHOCK BUILD:
BAG 9
GATE 01
SHOCK BUILD:
BAG 9
GATE 02
SHOCK BUILD:
BAG 9
GATE 03
13
33.657120, -117.701139
x2
x1
x1
x1
x1
x2
x1
x1
x1
x1
x1
x1
6299
E-Clip
42081
Shock
Piston
42040
Enduro
Rod Ends
42083
Shock Shaft,
3x30mm
42082
Shock Body,
10x32mm
5407
O-Ring,
Red
42081
Shock O-Ring
Spacer
42080
Shock Bottom
Cap
42080
Shock Cap,
Enduro
Shock Bleeding Steps:
1.
Pull shock shaft down.
2.
Fill shock body 3/4 full with silicone fluid.
3.
Slowly move the shock shaft up and down to remove air from
under piston.
4.
Wait for bubbles to come to surface.
5.
Fill shock body to top with silicone fluid.
6.
Place a drop of oil in the cap and on cap threads.
7.
Install cap and tighten completely.
8.
Slowly compress shaft all the way to the top. If there is
pressure at the top of the stroke, there is too much oil or air.
You must bleed it out.
9.
Slowly pull shaft out.
10.
Unscrew the cap 3/4 turn and tilt the shock at a slight angle.
11.
Slowly compress the shaft to push out excess oil and air.
You should see bubbles coming out from under the cap.
12.
With the shaft compressed, tighten the cap and re-check for
pressure at the top of the stroke. If there is still pressure,
repeat steps 9 thru11.
42081
O-Ring, Small,
Shock Cap
42081
O-Ring, Large,
Shock Collar
42079
Shock Collar,
Black, Aluminum
SHOCK FL
UID
#5422
SHOCK FL
UID
#5422
SHOCK FL
UID
#5422
SHOCK FL
UID
#5422
SHOCK FL
UID
#5422
Step 8-12
Step 1-3
Step 3-4
Step 5-6
Step 7
NOTE:
Seat O-Ring into
the groove on the inside
of the shock collar
NOTE:
Build 4
complete shocks
Pro Tip:
Use #1105 Green
Slime on O-Rings
NOTE:
Build 4
complete shocks
SHOCK CAP
O-RING
SHOCK COLLAR
O-RING
x1
31510
2x4mm
BHCS
x1
x1
42080
Shock Spring
Cup
3mm
42089
Shock Spring,
Gray, 1.49 lb/in, 63mm
NOTE:
Build 4
complete shocks
