20
to exit setting mode when in UPS
setting mode,but save nothing.
UP
•
Up key: Press this button to display
previous selection in UPS setting
mode.
DOWN
•
Down key: Press this button to
display next selection in UPS setting
mode.
•
To confirm selectionand exit setting
mode:Press this button to confirm
selection and exit setting mode
when LCD display the last selection
in UPS setting mode.
UP + DOWN
•
Setting mode: Press and hold this
button for 5 seconds to enter UPS
setting mode.
3.2 Setup the UPS
Step 1:
UPS input connection
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
•
For 208/220/230/240VAC models: The power cord is supplied in the UPS package
Step 2: UPS output connection
•
For socket-type outputs, simply connect devices to the outlets.
•
For terminal-type input or outputs, please follow below steps for the wiring
configuration:
a)
Remove the small cover of the terminal block
b)
Suggest using AWG14 or 2.1mm2 power cords for 3KVA
(208/220/230/240VAC models).
c)
Upon completion of the wiring configuration, please check whether the wires
are securely affixed.
d)
Put the small cover back to the rear panel.
Step 3: Communication connection
Communication port
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB/RS-232 port and the other to the
communication port of your PC. With the monitoring software installed, you can
