8
DPS Alarms(Ax sensor)
19 1 byte
0x00 = OFF, 0xFF = ON Default is 0xFF or ON.
Used to enable/disable door condition alarms for locks
that support a door position sensor. Any lock that does
not support DPS will always report 0x00.
Deadbolt Installed
20 1 byte
0x00 = NO deadbolt , 0xFF = YES deadbolt
Read only parameter. Some locks contain optional
deadbolt hardware. This parameter is used to
determine if one is installed.
Eco Mode On/Off
21 1 byte
0x00 = OFF, 0xFF = ON default is 0x00 or OFF
If supported switches lock to lower power mode of
operation with reduced sound and led brightness.
Privacy Mode with
Deadbolt
22 1 byte
0x00 = OFF, 0xFF = ON default is 0x00 or OFF
If enabled then extending the deadbolt will put the lock
into Privacy Mode.
Lock Body Alarms Mask
23 1 byte
Each bit controls one alarm. 1 = alarm enabled, 0 =
alarm disabled.
0xFF = All Alarms on, Default is 0xFF.
Bit 0: DPS Alarm (AX) (Duplicate of parameter 19.
Values should be tied together)
Bit 1: Deadbolt Alarm
Bit 2: Lever Rotated (Rx)
Bit 3 – 7: Not Used
*** - Additional hardware required. These parameters are only active if the optional Door Position
Switch has been installed with the lock.
