4
800-810-WIRE (9473) • www.sargentlock.com • A7755A
Profile Series v.G1 Cylindrical Lock
Copyright © 2004, 2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibite
d.
Left Hand
Hinges Left.
Open inward.
“LH”
Left Hand
Reverse Bevel
Hinges Left.
Open Outward
“LHRB”
Right Hand
Hinges Right
Open Inward.
“RH”
Right Hand
Reverse Bevel
Hinges Right.
Open Outward.
“RHRB”
View lock body from top and from the outside (as shown above)
Bevel
Latchbolt
Right Hand
Right Hand
Reverse Bevel
Left Hand
Reverse Bevel
Lock Body
Verify hand and bevel of door
Connector and Wires
Deadbolt
Guardbolt
Latchbolt
Front
Top
Lock w/cylinder
Override
(Shown)
End Cap
Installation Instructions
6
1. Verify Hand and Bevel of Door
2. Door Preparation
Prepare door according to appropriate template
(see website www.sargentlock.com):
• For metal door template, see 4531 and 4532
• For wood door template, see A7456 and A6719D
• Prior to installation, all holes must be free of burrs, debris
and sharp edges
• If doors are not properly reinforced per ANSI115.2,
commercially available reinforcements
should be installed
Stand on outside/locked side of the door when determining the door hand
Wood Door Preparation
1-1/2"
(2) 1/8" Dia. holes x 1/4" Deep
required
7/8"
Through-bolt
hole (2)
CL of
1-1/2" Dia.
1-1/2"
(2) 1/8" Dia. holes
required
7/8"
Fire
stop plate
Through-bolt
hole (2)
(2) Self tapping
screws #8 x 1/2"
long for wood
& metal doors
Slot
CL of
1-1/2" Dia.
Lockbody
hole
Latchbolt
door prep
Pre-drill
and/or tap
holes (2)
Inside
of door
Outside
of door
Hole for ribbon
cable from keypad
to controller
A7755A.indd 4
11/9/18 12:05 PM
