ISW73ER Rev 1 10/21
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
7
Model W73ER,
Wood Frame
I. Attach arm to track.
1. With provided 1/8" hex wrench, completely
tighten latch and sweep valves by turning
clockwise. This will allow for an easier closer-
to-door connection. (Figure 10)
CAUTION: Arm will be under strong spring force
to return if valves are not tightened completely
closed.
2. Open door to about 45° then rotate arm over
to door.
NOTE:
• With latch and sweep valves tightened,
arm will maintain position.
• If door is opened beyond 45°, backcheck
may need to be adjusted counter
clockwise to easily rotate arm to door
position.
3. Install slider centering hub through arm into
slider. (Figure 11)
NOTE: Countersink recess should face up.
4. Align hub initially as shown and insert two
(2) 10-24 x 3/8" adjustment set screws. Turn
both set screws just enough to retain slider
centering hub. Do not tighten firmly at this
time. (Figure 12)
NOTE: Align square shank of slider with
square in centering hub for proper fitment.
5. Insert arm attach screw, 1/4-20 x 3/4" FH-Allen
w/Nylon Patch, and tighten. (Figure 11)
6. Open latch and sweep valves to allow door to
close and observe door and frame alignment.
If door is not resting against emergency stop
release device when closed, reopen door
and use 5/16" hex wrench to rotate slider
centering hub until door comes to rest
against ERS device. (Figure 13)
NOTE:
DO NOT fully open valves. Valves will leak.
7. When door is completely aligned, tighten
both adjustment set screws.
Figure 11
Sweep
Latch 1 = Left Hand
Latch 2 = Right Hand
Backcheck
Figure 10
Slider
Centering Hub
Slider
Adjustment
Set Screws
Figure 12
Adjustment Hex
Arm Attach
Screw
Adjustment Set Screw
Adjustment
Set Screw
Installation
Dimension
Varies With Frame
And Door Thickness
2" (51mm)
ERS Device
Side
Closer
Optional Retro
Track Spacer
Door
Frame
Figure 13
Approved 2021-10-20
