8
23. Date/Time? / Next step
Select date/time? To go back to step 22.
Select next step to progress.
24. Start walk test (OK?)
Follow the on-screen instructions to test all the
learnt-in devices except the siren.
• Press the test buttons on the PIR and door contact
and the arm keys on the keyfob and keypad to
send a test signal.
• The walk test can be quit at any time by pressing
the
X
key.
• Walk test is used to check that the sensors are
working correctly. Walk test can also be used
to find out if the devices are in radio range of the
control panel.
• The control panel will chime and display the device
that sent the test signal.
25. Test device ? / Next step
To re-test press the
p
key and
3
, otherwise
press
3
directly to go to the next step.
26. Setup finished (OK?)
Press
3
and “
Start again?
” will be shown, to
restart press the
p
key and
3
, otherwise
press
3
directly to go to finish.
• The control panel will display “
Alarm off
” with the
time and date.
• More advanced programming, such as adding
contactless tags, device naming, entry/exit times,
adding other users and any corrections can be
made in the main programming menu, see section
5 Control Panel Menu System in Detail.
• All the devices are set-up as burgular mode. This
will result in the siren ringing instantly when you
enter the house (no countdown). You need to setup
an entry device if you want a countdown period.
See Edit device on page 13.
Steps continued...
