background image

 

End Plate Installation Instructions:

End Plate

1.  The automatic door bottom must be correctly installed and adjusted in  

 

accordance with the installation instructions furnished with this product  

 

(see other side).

2.  Be sure that the drop bar (part that contains the seal) does not project 

 

beyond the end of the case when the actuation plunger is depressed (as  

 

shown in Figure 7). If it does project beyond the case, it was improperly  

 

trimmed in the field. This condition can be corrected by removing the unit  

 

and trimming the excess.

 

NOTE: Under no condition should the insert project beyond the edge of  

 

the case.

Figure 7 - Improper Drop Bar

This shows an improper drop 

bar protruding from the end of 

the case. The drop bar should be 

flush at both ends.

Drop Bar

Figure 8 - Properly Installed End Plate

This shows a properly installed 

end plate. Do not use power tool 

to tighten this screw.

End Plate

Figure 5 - Plunger End Plate

Figure 6 - End Plate

3.  Insert the No. 10 x 1/2” flat head screw into the central opening of the endplate and tighten with a small Phillips   

 

screwdriver. Insert the end plate into the case at the lock edge side of the door. Power drivers are not suggested   

 

as they may over-tighten the screw and possibly break the end plate (as shown in Figure 8).

4.  Next insert the plunger end plate with the hexagon hole. This pushes straight in. It also serves to prevent the  

 

 

plunger from rotating and changing adjustment (as shown in Figure 9 and Figure 10). If this end plate needs to    

 

be removed for readjustment, it can be removed in two ways: (1) push the drop bar towards the hinge side of the  

 

door and it will eject the end plate; (2) prying at the top of the end plate with a knife or other tool. Do not pry at  

 

the bottom. This  will cause it to break.

Figure 9

Plunger end plate prevents 

the plunger adjustment from 

rotating.

End Plate

Plunger

Plunger

Figure 10

Plunger end plate installed.

PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE ATTEMPTING TO INSTALL END PLATES.

IMPORTANT! These parts are made from glass filled nylon. They are very strong, but brittle. Do not attempt to twist or 

bend them or they will break. This is not a problem if properly installed or removed.

Отзывы: