2. TRANSFER the location of the inside wall of the cabinet to the door.
2a. MEASURE the horizontal distance between the inside edge of the cabinet and the door edge.
NOTE: The drawn line depicts the location of the strike mounting surface.
2b. DRAW a line on the outside surface of the door, using the same distance away from the door edge.
3. PLACE and USE the Lock/Reader Template.
NOTE:
Orientation will be reversed for a right hand door.
3a. CUT through line to separate the Strike Plate Template.
3b. PEEL OFF the protective layer of the Lock Template, ALIGN it to both the latch
centerline and the line depicting the inside wall of cabinet, and PRESS to
secure.
NOTE: Two of the holes in the following step are 3/16” diameter and two are
1/2” diameter. The two pilot holes are 1/16”.
3c. DRILL four holes and two pilot holes through the cabinet, as shown
in the figure below.
3d. DRILL only one 3/16” hole depending on the desired
Antenna/Reader orientation.
3e. IF the optional Key Override will be installed,
THEN GO TO Step 5.
3f. REMOVE the lock template from the door.
Cabinet/door front view
Door edge
2a
2b
3a
3b, 3c, 3d
3080076.004, Rev. B
7
