15
Alarm Length
The siren (both external and built-in) will sound when
an alarm is activated. The length of the alarm can be
set from 1 to 15 minutes in 1 minute increments with
this setting.
• 3 minutes is the factory default.
C.U. Siren
You can disable the control unit’s built-in siren with
this setting.
• Siren on is the factory default.
Jamming Det
Enable or disable Jamming/Interference detection on
the control panel. Confirmed by pressing the
3
key.
Default setting is Disable (recommended).
KF Entry
When selected as Off, user must first trigger an entry
sensor before the keyfob can disable the system.
Please select On if you wish to disarm the system
without first triggering an entry sensor.
• KF Entry On is the factory default.
• If the Keyfob’s Panic button is triggered, the
same keyfob cannot be use for disarming the siren.
Time
The control unit uses a 24 hour clock. The time
is set by using the
pq
keys and confirmed by
pressing the
3
key.
Date
The day and month are set by using the
pq
keys
and confirmed by pressing the
3
key.
Final Door
If this is turned On, a system counting down under
the full arm mode will immediately arm when user
exit and triggers the Door contact’s close position
(Applies to door contact with “entry” attribute only).
• Final Door Off is the factory default.
Tel. Settings
This menu allows you to program up to 3 telephone
numbers, record an address message and place
test calls, The following items can be selected.
• Tel. Numbers
• Rec. Msg
• Test Report
Tel. Numbers
This menu has a list of 6 telephone numbers (notify
via voice dial or SMS). These numbers are dialled/
SMS in order, a maximum of 20 digits per number
can be stored. Only one number is required to
enable the control unit to report over the telephone
line.
1
Use the
pq
keys to select a number from the list.
2
Press
3
to confirm. If there was a number already
stored then you will be asked to change the
number, if the slot was empty you will be asked to
enter a new number, confirm by pressing
3
.
3
Enter your phone number and confirm by
pressing
3
. Errors can be corrected by pressing
P
to backspace, pressing
P
repeatedly will take
you back the telephone number list. Telephone
numbers can be deleted in the same manner.
4
Once a number is entered, you will be ask whether
to use voice or SMS reporting. Please note
that SMS reporting can only work with mobile
numbers. If you select SMS reporting, it will further
ask you what type of event should trigger a report.
Rec. Msg
This menu allows the recording of your message.
The maximum length of message is 10 seconds
which is ample for most messages, when recording
remember to speak clearly and slowly into the
microphone.
1
Press
3
and you will be either asked to record a
new message or change an old one.
2
Press
3
again and follow the on screen
instructions. When you finish recording remember
to press
3
to stop recording. If you go over the
10 second recording time (indicated by a beep)
just repeat the recording procedure again taking
care not to go over the 10 second time limit. The
recording is complete.
Test report
This menu allows you to test the telephone reporting
feature.
• Please check with the call recipients before making
a test call.
• Ensure that the sim card is inserted and working.
The sim card should not have pin code protection.
