4
of 4
Adjusting the Shim
NOTE: To adjust the shim height, it is necessary
to power the electric strike to open keeper.
1.
LOOSEN the locking screw with
the 5/64" Hex Wrench.
2.
ADJUST the shim height to the
desired level by turning the upper and
lower set screws (clockwise to raise
and counterclockwise to lower).
3.
TIGHTEN the locking screw
to lock position.
Replacing the batteries
1.
REMOVE the secure screw on the bottom of the unit
using a tamper resistant T8 bit or driver (
Diagram 9
).
2.
REMOVE the reader cover from the
backplate (
Diagram 9
).
NOTE:
Be careful to not damage the main
power cable harness during separation.
3.
Carefully remove both AA lithium batteries and
dispose of the used batteries promptly.
WARNING:
Keep away from children. DO NOT
disassemble and do not dispose of in fire.
4.
INSTALL new AA lithium batteries
based on proper polarity.
5.
Reverse steps 2 and 1 to secure the
cover to the backplate.
Diagram 7
Locking
screw
Micro USB Port
For emergency power & local (hard wired)
firmware updates, use micro USB port
located on the side of the R100 reader.
NOTE:
Any 5V power jump device can power the ES100.
Micro USB Port Power Draw: 136 mA Peak at 5 VDC.
Diagram 8
Micro USB
[email protected] | assaabloyesh.com
800 626 7590 | 10027 S. 51st Street Phoenix, AZ 85044 USA
Patent pending and/or patent www.assaabloydss.com/patents
Copyright © 2021, Hanchett Entry Systems, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Hanchett Entry Systems, Inc. is prohibited. 3080006.024_1
Warranty
For information on warranty coverage and replacement options,
please visit
assaabloyesh.com/en/about/warranty.
Screw Mounting Holes
Wire Exit Hole
Peel Away
Diagram 9
Install Batteries & Secure Reader
