13
Configuration
EN
Note!
Commissioning:
All
Hi-O technology
™ devices must be connected to the bus for
the configuration. Then the operating voltage is switched on. Subsequently
connected devices are only recognised after renewed connection of the operat-
ing voltage.
At least one Emergency Open module is always necessary for operation of the
RWT locking module.
1 Configure the system via the
ePED
®
Service Software
(
D01104xx ePED
®
Service
Software
) manual).
Display
The
display
shows the current system
status. Operation takes place interac-
tively via the touchscreen (Fig. 3).
If no input takes place, the display
switches back to status display after 15
seconds.
The display shows operating symbols in
the header area and information for
interactive communication with the
user.
The toolbar is not always completely visible. One or two symbols are shown for
operation or navigation, a menu heading can be shown in the centre.
Authorisation
There are three authorisation levels:
Control
Authorisation for calling up information
Settings
Authorisation for calling up information and
restricted configuration
Installation
Authorisation without restrictions
Each authorisation level is assigned a clear authorisation code in the factory.
These authorisation codes must be changed for commissioning. Each authorisa-
tion level must be assigned a clear authorisation code once again.
I
Fig. 3 :
The display shows
operating symbols
and information
on the door status
or communication
Tab. 2 :
Authorisation
levels
Configuration
