STEP 3: Chassis Installation
Install an alignment spacer on to each chassis (one
oriented up, one oriented down to match plate insert
in bore)
Insert (2) mounting posts through the chassis on the
outside of the door
Install (2) #8-32x5/8 machine screws with integrated
lock washer through the chassis on the inside of the
door to secure
Make sure the chassis’ are square to the door and
fully tighten screws
Fully tighten latch screws
Install surface mounted screws to secure alignment
-
For wood doors: 7/64” pilot hole
-
For metal doors: drill and tap for #8-32 screw
Check operation by turning cams by hand. If binding
occurs loosen chassis mounting screws and
retighten
For privacy function install push button on inside of
door
If trim is mounted VERTICAL and the end of the paddle will
point towards the HINGE, attach the insert to the paddle in
the orientation shown:
The paddle has three potential orientations:
-
VERTICAL
-
HORIZONTAL – UP
-
HORIZONTAL – DOWN
The insert is attached to the paddle using
(2) #8-32 x 5/16” Machine Screws (VC-3
Coated)
STEP 4: Determine Orientation of Paddle
If trim is mounted HORIZONTAL and the end of the
paddle will point UP, attach the insert to the paddle in
the orientation shown (same as vertical):
If trim is mounted HORIZONTAL and the end of the
paddle will point DOWN, attach the insert to the paddle in
the orientation shown:
Copyright © 2011, Corbin Russwin, Inc., an ASSA ABLOY Group Company.
All rights reserved. Reproduction in whole or in part without the express
written permission of Corbin Russwin, Inc. is prohibited.
ASSA ABLOY, the global leader in door opening solutions
Note orientation
of insert lobes
