7
ED5860 (B) Series
Installation Instructions
Exit Device
FM544 02/20
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 1998, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
c
Mark Door
Single Door or Pair without Mullion:
• Locate and mark horizontal and vertical
centerlines as shown. (Figure 6)
• LHR door shown. Preparation is typical for
both door hands. (Figure 6)
Caution:
If device is mounted higher or lower than shown,
rod length must change. Lengthen or cut top
and bottom rods as shown in
"
"
on page 9.
Note:
Bottom bolt will retract to 1/8
"
(3mm) above floor
strike. Floor covering in the door path must be laid
accordingly.
Figure 6
LHR Door
Inside Face
Door
Door
Measure Gap
Write Dimension Here: _____
Centerline
Vertical
Reference
Centerline
Horizontal
Reference
39-15/16
"
(1014
"
)
