ASROCK M3A785GXH/128M, Руководство по установке

Страница: 37 / 216

3 7 3 7 3 7 3 7 3 7
ASRock M3A785GXH/128M Motherboard
C
B
A
HDMI_SPDIF Cable Please connect the black end (A)
(Optional)
of HDMI_SPDIF cable to the
HDMI_SPDIF header on the
motherboard. Then connect the
white end (B or C) of
HDMI_SPDIF cable to the
HDMI_SPDIF connector of HDMI
VGA card.
A. black end B. white end (2-pin) C. white end (3-pin)
EnglishEnglishEnglishEnglishEnglish
4
1
8
5
2.10 eSA 2.10 eSA
2.10 eSA 2.10 eSA
2.10 eSATTTTTAII Inter AII Inter
AII Inter AII Inter
AII Interface Introduction face Introduction
face Introduction face Introduction
face Introduction
NOTE:
1. If you set “SATA Operation Mode” option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or remove
your eSATAII devices to the eSATAII ports while the system is power-on and in
working condition.
2. If you set “SATA Operation Mode” option in BIOS setup to IDE mode, Hot Plug
function is not supported with eSATAII devices. If you still want to use eSATAII
function in IDE mode, please insert or remove your eSATAII devices to the eSATAII
ports only when the system is power-off.
3. If you want to use the eSATAII HDD as an OS disk, please set “SATA Operation
Mode” option in BIOS setup to IDE mode. If you want to use the eSATAII HDD
as a removable data disk, please set “SATA Operation Mode” option in BIOS setup
to RAID mode. If you want to add the eSATAII HDD as a RAID disk, please set “SATA
Operation Mode” option in BIOS setup to RAID mode.
4. Please do not configure your eSATAII HDD as a RAID disk; otherwise, it may affect
the Hot Plug function that eSATAII HDD should have.
5. Please refer to page 39 to 40 for detailed information of RAID mode, IDE mode and
AHCI mode.