18
3W Audio AMP Output Wafer
(4-pin SPEAKER1)
(see p.8 No. 34)
SATA3 Connectors
These two Serial ATA3 (SATA3)
(SATA3_1~2: see p.8, No. 6)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Front Panel Audio Header
This is an interface for front
(9-pin HD_AUDIO1)
panel audio cable that allows
(see p.8 No. 33)
convenient connection and
control of audio devices.
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC’97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don’t
need to connect them for AC’97 audio panel.
E. To activate the front mic.
Go to the “FrontMic” Tab in the Realtek Control panel. Adjust
“Recording Volume”.
USB 2.0 Headers
There are two headers on this
(9-pin USB2_5_6, USB2_10_11:
motherboard. Each USB 2.0
see p.8, No. 35)
header can support two ports.
SATA3_1
SATA3_2
USB 3.2 Gen1 Header
There is one header on this
(19-pin USB3_4_9,
motherboard. This USB 3.2
(see p.8, No. 36)
Gen1 header can support two
ports.
1
In
Dummy
IntA_PB_D-
GND
IntA_
GND
IntA_PB_SSTX-
IntA_
IntA_PB_SSRX-
Vbus
Vbus
Vbus
IntA_PA_SSRX-
IntA_
GND
IntA_PA_SSTX-
IntA_
GND
IntA_PA_D-
In
J_SENSE
OUT2_L
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
1
1
PIN Signal
Name
PIN
Signal
Name
PIN
Signal
Name
PIN
Signal
Name
1
OUTLN
2
OUTLP
3
OUTRP
4
OUTRN
