ASROCK 939SLI32-ESATA2, Руководство по установке

Страница: 17 / 152

1 7 1 7 1 7 1 7 1 7
ASRock 939SLI32-eSATA2 Motherboard
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
connect the black end
to the IDE devices
Primary IDE Connector (Blue) Secondary IDE Connector (Black)
(39-pin IDE1, see p.2 No. 11) (39-pin IDE2, see p.2 No. 12)
Note: If you use only one IDE device on this motherboard, please set the IDE
device as “Master”. Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
SATAII_RED and SATAII_ORANGE connectors can be used for internal
storage devices or be connected to eSATAII_BOTTOM and eSATAII_TOP
connectors with corresponding color to support eSATAII devices. Please
read “eSATAII Interface Introduction” on page 21 for details about eSATAII
and eSATAII installation procedures.
eSATA II Connectors These two eSATA II
(eSATAII_TOP: see p.2, No. 39)
connectors support SATA
(eSATAII_BOTTOM: see p.2, No. 38)
data cables for external
SATAII function. The current
eSATA II interface allows up to
3.0 Gb/s data transfer rate.
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
You can also use the SATA data
cable to connect SATAII connec-
tors and eSATAII connectors
with corresponding color.
Serial ATA II Connectors These four Serial ATA II
(SATAII_BLUE: see p.2, No. 14)
(SATAII) connectors support
(SATAII_BLACK: see p.2, No. 13)
SATA data cables for internal
(SATAII_RED: see p.2, No. 16)
storage devices. The current
(SATAII_ORANGE: see p.2, No. 17)
SATA II interface allows up to
3.0 Gb/s data transfer rate.
eSA
T
AII_T
O
P
eSA
T
AII_BOTT
O
M
SA
T
AII_BLACK
S
A
T
AII_BLUE
SA
T
AII_ORANGE SA
T
AII_RED
EnglishEnglishEnglishEnglishEnglish