Aspes ATE15C, Инструкция по эксплуатации и техническому обслуживанию

Страница: 2 / 16

2
Instructions for use and maintenance
EN
Dear Clients,
Our team would like to congratulate you on your
new purchase. We hope that your new appliance
shall bring more comfort to your home.
This technical description and instructions manual
was prepared in order to acquaint you with the
product and the conditions of proper installation and
use. These instructions were also intended for use
by qualified technicians, who shall perform the initial
installation, or disassembly and repairs in the event of
a breakdown.
Please consider that following the current
instructions will primarily be of interest to the
consumer, but along with this, it is also one of the
warranty conditions, pointed out in the warranty
card, so that the consumer can benefit from the free
warranty services. The producer is not responsible
for damages in the appliance that have appeared
as a result of operation and/or installation not
corresponding to the instructions here.
The electric water heater complies with the
requirements of EN 60335-1, EN 60335-2-21.
I. INTENDED USE
The appliance is intended to supply hot water to
household sites equipped with a piping system
working at pressure below 6 bar (0,6Mpa).
It is designed to operate only in closed and heated
premises where the temperature is not lower than 4
°C and it is not designed to operate in a continuous
protracted regime.
The appliance is designed to operate in regions where
the water hardness is not more than 10 °dH. In case
that it is installed in a region where the water is harder
it is possible that limestone precipitation accumulate
very fast. This can cause a specific noise during
heating, as well as fast damaging of the electrical
part. For regions with harderwater yearly cleaning
of the limestone precipitation in the appliance is
recommended, as well as usage of not more than 2
kW of heating power.
II. TECHNICAL PARAMETERS
1.
Nominal volume V, liters - see the appliance’s
rating plate.
2.
Nominal voltage - see the appliance’s rating
plate.
3.
Nominal power consumption - see the
appliance’s rating plate.
4.
Nominal pressure - see the appliance’s rating plate.
This is not the water mains pressure. This is
the pressure that is announced for the
appliance and refers to the requirements of the
safety standards.
5.
Water heater type - closed type accumulating
water heater, with thermal insulation.
6.
Daily energy consumption – see Annex I
7.
Rated load profile - see Annex I
8.
Quantity of mixed water at 40 °C V40 litres - see
Annex I
9.
Maximum temperature of the thermostat - see
Annex I
10.
Default temperature settings - see Annex I
11.
Energy efficiency during water heating - see
Annex I
III. IMPORTANT RULES
•
This appliance is intended for domestic use only.
•
The water heater must only be mounted in premises with normal
fire resistance.
•
Do not switch on the water heater unless you established it was
filled with water.
Attention! Improper installation and connection of the
appliance may make it hazardous for the health and life of
consumers. It may cause grievous and permanent consequences,
including but not limited to physical injuries and/or death.
Improper installation and connection of the appliance may also
lead to damage to the consumers’ property /damage and/ or
destruction/, or to that of third persons, as a result of, but not
limited to flooding, explosion and/or fire. I
nstallation, connection to
the main water and power supply, and putting into operation must be
carried out by certified electricians and technical personnel certified in
installation of this category of appliances, who have obtained their
license in the state where the installation and commissioning of the
appliance are carried out, and in compliance with its local legislation.
•
Upon connecting the water heater to the electric mains care must