Aspes AAC3000, Инструкция по установке и эксплуатации

Страница: 15 / 44

Warning:
Must install drainpipes according to the following figure , avoiding generating condensed
water and leakage water.
a.Assemble the main body according to Figure .
b.The opening of drainpipes can be installed on the leftside or the right side . Could remove
the drainstopper and put it on the left side or the right side.
c.For the best effect, should keep pipes as short as possible. Tilt the pipes to ensure the flow
of fluid.
d.Make sure the drainpipes have admirable heat insulation.
e.It is necessary to install a trap near the opening of the drainpipe,so that when the machine is
working, the pressure in the inside of the machine is lower than atmospheric pressure. If there
isn't a elbow , the water will splash and the pipe will produce a bad smell.
f.keep straightness of drainpipes so as to remove dirt.
g.Seal the drainpipe on the other side of the machine , then wrap up the drainpipe in the
heat-barriermaterials .
h.Put water into the drain pan to test whether the water can be discharged swimmingly.
i.In humid conditions , please must use a add-on drain pan(commercially available) to cover
the whole area of the indoor unit.
Indoor unit
Heat insulation
Site Preparation
Add-on drain pan
(sold separately)
Drain stopper
Heat insulation
Site Preparation
The structure of the drainpipe
should be convenient for clean.
Trap
Bottom of unit body
50
50
Unit:mm
Tilt
Hight static pressure drainage pipe installation
13