SMC02G/SMC02F/Variants - Product Manual
10 Safety
and
Precautions
10.4.1 Packing for Return for Repair
All electronics assemblies must be
properly packed in ESD protective
packing for transport, to prevent
physical and ESD damage. Use of
non-ESD protective packing for return
for repair or service will automatically
invalidate the warranty.
!
!
10.1 Environmental
The temperature and humidity ranges shown in
the specifications for this product must not be
exceeded.
This equipment must not be installed in an area
that is subject to a corrosive atmosphere,
excessive moisture or may allow water or other
liquids to come into contact with the unit or its
external connections.
The filler material used for packing for
return for repair must be antistatic or
static dissipative, as this may come
into contact with exposed connectors,
wiring, or PCB assemblies. The use
of non-conductive filler material may
cause damage to the electronic
assemblies reducing their operational
life, or even destroying them, and it
will automatically invalidate the
warranty.
!
!
In the close proximity of some radio frequency
transmitters, the signal to noise ratio of this
product may be reduced. If this occurs, ensure
adequate system RF earthing or re-locate the
equipment or signal cables.
10.2 ESD
Advice on packing the product for return can be
provided by Application Solutions Limited.
This product contains static-sensitive devices.
Observe ESD precautions when working on the
equipment with the cover removed.
10.3 Electrical
Safety
Always replace blown fuses in the supply to this
equipment with the correct type and rating.
Ensure power supply cabling is adequately rated.
10.4
Unpacking and Handling
The equipment should be unpacked and
inspected immediately on receipt. If damage has
occurred please advise your carrier or supplier.
It is advisable to retain the original equipment
packing in the event that the equipment ever
needs returning for service.
Ensure that the name and address of the
Authorised Distributor from whom you purchased
the unit is recorded on the “
Service and Warranty
”
page of this manual for future reference.
This equipment contains electronic devices that
are sensitive to electrostatic discharge. Please
take precautions to avoid damage to the
electronics by static electricity.
Issue: 02 complete, approved
Page 55 of 60
Содержание SMC02
Страница 60: ......
