10
Installing lens port
1.
Locate the notch that is ma-
chined on the front lens port. Slide
the camera lens into the lens port
and line up the Iris bushing with
the notch so the camera lens sits
properly in the port. At the same
time, inspect the o-rings on the
lens port in order to see if there is
dirt or debris. If any, gently wipe
it off with your finger or a lint free
tissue. Add some silicone grease
(provided) if necessary.
2.
Pass the connector through
the rear bulkhead, then through
the main body. Leave enough
loose cable so you can handle the
connector easily. The back pre-as-
sembly should look like the image
beside.
3.
Once the camera lens is secure-
ly installed in the port, push them
into the main body until the white
spacer rests against the main
body. You may feel a bit of friction
while inserting the port. This is due
to the o-rings creating a correct
seal.
Also, make sure that when in-
serting the camera head into the
main body that both the camera
and main body inside profile mate
correctly. This way, you assure a
perfect fit.
Installing lens port
