Asko WCAM1812, Руководство пользователя

Страница: 3 / 60

CUSTOMER CARE CENTER 800.898.1879 www.askousa.com
I N S TA L L AT I O N R E Q U I R E M E N T S
Grounding Instructions
This appliance must be properly grounded. In the
event of breakdown or malfunction, grounding
reduces the risk of electric shock by providing a
path of least resistance for electric current. The
cord for this appliance has an equipment-grounding
conductor and a grounding plug. The plug must
be plugged into an outlet that is properly installed
and grounded in accordance with all local codes
and ordinances. Do not modify the electrical plug
provided with the appliance – if it does not fit the
electrical outlet, have a qualified electrician install
a proper outlet. Make sure the power supply and
electrical outlet support a 110/120V, 15 amp
single-phase circuit.
Warning!
Improper connection of the equipment-grounding conductor may
result in electric shock. If you are in doubt as to whether the
appliance is properly grounded, check with a qualified electrician or
service representative.
Important!
To prevent accidents, injury and fire, read instructions carefully before
you install the machine.
A qualified installer familiar with all local codes and ordinances for
plumbing and electricity should do the installation and grounding.
Incorrect installation may cause damage or injury.
Install washer/dryer on a strong, level floor in a protected, dry and
well-ventilated area with room for electrical cords and hoses behind
the machine. Temperature should be not less than 38° F (3° C)
Make sure power supply and outlet support a 110/120 V, 15 amp
single-phase circuit.
Do not use an extension cord.
If integrity of the machine is in doubt, do not use it. Call Customer
Care Center at 800-898-1879.
Electrical
Machine Voltage/Amperage – 120V, 60Hz, 15 Amp
Connection – 3-prong plug (must be grounded)
Circuit/Protector – single phase, 15 AMP, 120V, 60Hz
3
Location
The washer/dryer can be installed as a freestanding unit
or in a recessed area, under a counter or in a closet with
appropriate clearance. See page 4
.
FILL/DRAIN HOSES
Fill Hoses – Two hoses are supplied with the machine. The hot
water hose has a red stripe running the length of the hose.
Drain Hose – Drain outlet should be between 23” (60 cm) and
35” (90 cm) above the floor. To prevent siphoning, do not seal
the drain hose connection into the drain outlet. If machine
is not connected to a drain outlet, position drain hose and
bracket over the edge of sink or wash basin and secure in
place before draining. See page 5 for complete installation
instructions for the fill and drain hoses.
ASKO denies all liability if installation use and care instructions
are not followed completely.
Tools
1. Adjustable Wrenches
(if you use adjustable
fittings)
2 Open-ended Wrench
[10mm]
3. Tape Measure
4. Spirit Level
5. Channel Lock
6. 20 Torx screwdriver