Asko W6864W, Руководство по эксплуатации

Страница: 22 / 32

22
Troubleshooting
Error messages
If an error occurs during the programme a
message is shown on the display. To exit the
message after taking measures, turn the
machine off and then back on.
The error messages that may be shown in the
display are:
Close the Door
Close the washer door and press Start to start
the programme.
Over flow fault
1. Shut off the water tap.
2. See "Drainage error".
Water outlet fault
Check:
• that no objects are stuck in the drainage hose
outlet.
• that the drainage pump is not blocked by
foreign objects. Clean the pump. See the
"Care and cleaning" chapter.
• that there are no kinks in the drainage hose.
After the above, run Drain to empty the machine.
If this does not resolve the problem, call the
service division.
Water inlet fault
Check:
• that the tap on the water pipe is open.
• that the filter in the machine’s water intake is
not blocked.
Action:
1. Shut off the water tap and unscrew the hose.
2. Clean the filter in the intake valve on the
machine.
3. Screw the hose back on and turn on the tap.
4. Run the program again to check if the fault is
fixed.
5. If this does not resolve the problem, call the
service division.
Wash motor fault
Call the service division!
Unbalance
The machine stops the spin cycle if there is too
much imbalance.
The washing machine restarts the spin cycle
and hopefully the washing is better distributed in
the drum. This procedure can be repeated up to
10 times. If the machine still fails to find a good
balance, the programme jumps to the next step.
The error message requires no action.