Asko TDC145V, Руководство по установке

Страница: 12 / 56

12
English
The tumble dryer can be free-standing or
in a stack. Remember that the tumble dryer
produces heat and should therefore not be
located in a room that is too small. If the room
is very small, drying will take longer due to the
limited quantity of air.
Tip!
• Do not install the machine in a room
where there is a risk of frost occurring.
At temperatures around freezing point
the machine may not be able to operate
properly.
• The room in which the appliance is installed
should be adequately ventilated, with
temperature between 15°C and 25°C.
Caution!
• Any electrical installation must be carried
out by qualifi ed professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
• The tumble dryer’s plinth ventilation must
not be blocked by a rug or the like.
Tip!
• To improve ventilation, leave the door to
the room where the tumble dryer is located
open.
A. Freestanding
The tumble dryer can be positioned beside the
washing machine. An air gap of at least 5
с m
must be left between the washing machine and
the tumble dryer.
If the customer has a problem with the
machine sliding when on a low-friction fl oor,
the plastic cups can be used under the feet of
the tumble dryer (between foot and fl oor).
B. Stacking
The tumble dryer can be placed on top of a
ASKO washing machine. In this case you use
the stacking attachments (foot cups and anti-
tilt devices) that come with the machine. Two
rubber feet and two anti-tipping brackets are
supplied in the bag found in the drum of the
dryer.
How to assemble the stack:
1. Undo the screw on the back of the ASKO
washing machine as shown in the fi gure.
2. Secure the anti-tilt device using the screws
as shown in the picture.
3. Take the other anti-tipping bracket from
the bag and attach it on the dryer with two
screws as shown in the fi gure.
4. Place the two rubber feet on the front feet
of the dryer.
5. Fasten or undo the rear feet of the
appliance until it is fully level, either on the
fl oor or on the washing machine.
6. Slide the dryer backward until it reaches the
anti-tipping bracket. Make sure the front of
the appliance is raised by 50 to 150 mm as
you slide it back.
Adjusting the feet
Screw the feet in or out so that the tumble
dryer is steady and balanced on the fl oor or on
the washing machine.
Positioning the tumble dryer