Asko T794C FI, Руководство по эксплуатации

Страница: 26 / 32

5. Fit the plastic cups so that the “tags” marked
with arrows are against the front edge or side
edge of the cover and press them firmly onto
the cover. Then break off the remaining tags.
6. Push out the knock-out hole on the back of the
tumble dryer (you must not remove it, just open
it) using a hammer and screwdriver.
7. Push the tumble dryer in under the metal
brackets. While doing this, keep the front edge
raised by 10 mm to 20 mm.
8. Lower the tumble dryer’s front feet into the
plastic cups and adjust the tumble dryer to
ensure it is level.
Adjusting the feet
Screw the feet in or out so that the tumble dryer
is both stable and level.
Condensed water
The machine is supplied as shown in Option 1
(inset). This means that the condensed water is
pumped into the condensed water container,
which must be removed and emptied by hand.
Option 2 allows you to remove the small short
hose from the nipple. Attach the rubber hose
supplied to the same nipple. The water can then
be pumped out into a sink or a floor drain (2a).
2
1
2a
Max 1000 mm
Electrical installation
Connect the machine by plugging it into an
earthed wall socket. The electrical wall socket
must be placed outside of the installation area to
be easily accessible.
If this appliance is supplied from a cord extensions
set or electrical portable outlet device, the cord
extension ser or electrical portable outlet device
must be positioned so that it is not subject to
splashing or ingress of moisture.
Connection on delivery
• 230V, 1-Phase, 10A
• 50Hz
• Heat output 1950W
• Use a type A residual current device.
26
Installation