Asko PROFESSIONAL WMC943VS, Руководство по эксплуатации

Страница: 17 / 24

17
POSITIONING THE WASHING MACHINE
The washing machine can be installed as a built-in or
freestanding unit. Place the machine on a fi rm surface
with easy access to the plug.
A. Built-in
The washing machine can be installed under a counter
top with a working height of 850-900 mm. Leave a 5 cm
space around the entire machine, including between the
rear edge of the top cover and the wall behind it.
B. Freestanding
The washing machine can be positioned beside or under
a tumble dryer.
ADJUSTING THE FEET
Keep the noise that the machine produces to a minimum
by adjusting the feet so that the machine is steady and
balanced on he fl oor. Tighten the lock nuts.
Locking nut
CONNECTION TO WATER SUPPLY
Water connection should be carried out by an
appropriately quali fi ed person. Connect the machine
using the accompanyingsupply hose. Water pressure
should be 0.1–1MPa (approx. 1–10kp/cm
2
; 10–100N/
cm
2
). There should be a stopcock on the water pipe.
If the pipes are newly installed, it may be wise to
fl ush them through so that any dirt is washed away.
Otherwise, dirt can clog the fi lter in the machine’s water
intake and cut o ff the water supply.
Use only the supply hose supplied with the machine. Do
not re-use old hoses or other loose supply hoses.
Water intake
At the factory, the machine is set for connecting to both
hot and cold water supplies. The machine can be set for
cold water intake only. See the section “Settings”.
Hot water connection
(depending on the model)
A few seconds after you start a programme the washing
machine will begin to fi ll with water from both the hot
and the cold supplies. If for some reason no hot water is
available, the machine waits for one minute and then fi lls
with cold water only. The wash drum does not start to
rotate until it begins to fi ll with water.
If you choose to connect your ECO-machine to only the
cold water it is important that you shut o ff the hotwater
connection. Nowselect “Hot water O ff ”. If yourmachine is
connected to both hot and coldwater, you should select
“Hotwater On”.
If the appliance is not connected to the hot water line,
then deactivate the function in the User Menu.
(See chapter Settings.)
INSTALLATION