Asko PROFESSIONAL TDC111VG, Руководство по эксплуатации

Страница: 18 / 28

18
Installation
Positioning the tumble dryer
The tumble dryer can be free-standing or in a
stack. Remember that the tumble dryer produces
heat and should therefore not be located in a room
that is too small. If the room is very small, drying
will take longer due to the limited quantity of air.
NOTE!
Do not install the machine in a room where there
is a risk of frost occurring. At temperatures around
freezing point the machine may not be able to
operate properly.
The room in which the appliance is installed
should be adequately ventilated, with temperature
between 15 °C and 25 °C.
CAUTION!
• Any electrical installation must be carried out
by quali fi ed professionals.
• The machine must not be installed behind a
lockable door, a sliding door or a door with
hinges on the opposite side to those of the
tumble dryer.
• The tumble dryer’s plinth ventilation must not
be blocked by a rug or the like.
TIP!
To improve ventilation, leave the door to the room
where the tumble dryer is located open.
Freestanding
The tumble dryer can be positioned beside the
washing machine. An air gap of at least 5 mm
must be left between the washing machine and
the tumble dryer.
If the customer has a problem with the machine
sliding when on a low-friction fl oor, the plastic
cups can be used under the feet of the tumble
dryer (between foot and fl oor).
Stacking
The tumble dryer can be placed on top of a
washing machine. In this case you use the
stacking attachments (foot cups and antitilt
devices) that come with the machine. You will fi nd
two foot cups in a bag in the drum and two anti-tilt
devices are attached to the bottom left corner at
the back of the machine. Extending plates can be
ordered from your local retailer.
How to assemble the stack:
1. Undo the anti-tilt device. Fasten the screw
back into place
2. Undo the two screws indicated on the back
of the washing machine.
3. Secure the anti-tilt device using the screws
as shown in the picture.