Asko DW70.1, Руководство по обслуживанию

Страница: 8 / 33

8
Connection to water supply
The supply pipe must be fitted with a stop-
cock. The stopcock should be positioned
above the sink unit or at the front of the sink
unit cabinet.
The inlet pipe has a coupling with either a 1/”
or a /” internal thread, depending on the
country.
Once the machine in installed: Open the stop-
cock to flush the pipe. Check that all connec-
tions are watertight.
electrical connection
Machines fitted with a cable and plug must be
connected to an earthed socket.
Technical data
See the type plate on the right-hand side of
the door.
CAUTION!
The power cable must be disconnected or the
power to the socket turned off when work is
carried out!
Drainage connection
• The drainage hose connects to a connec-
tion nipple on the sink unit’s water trap (see
illustration below). Note that the hose must
be attached at the same height as the un-
derneath of the sink unit otherwise dishwater
from the sink may run down into the dish-
washer (see illustration).
• The drainage hose connects to a connection
pipe on the sink unit’s water trap. It must have
an internal diameter of at least 1 mm.
• The drainage hose may be extended to a maxi-
mum of m. Any connections and connecting
pipes must have an internal diameter of at least
1 mm.
• No part of the drainage hose may be more
than 950 mm above floor level.
The hose must not be routed directly to the
floor drain or similar. In such cases, the hose can
act as a siphon and empty the machine.
The hose must always discharge at least 50
mm above floor level.
• Attach the hose holder.
(Min. 50 mm and max. 950 mm above floor
level.
Figure 3.
hose holder
Max 950 mm
Min 350 mm
INSTAllATION