Asko D5894 XXL FI, Руководство по эксплуатации

Страница: 21 / 40

7
Press Start/Stop and close the
door
The display shows "Program started". Close
the door properly, otherwise the dishwasher will not
start.
Stopping or changing a program
If you want to change program after starting the
dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if
the lid of the detergent dispenser has opened. Then
choose a new program, press Start/Stop and close
the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically.
Add the dishes, close the door and the dishwasher
continues the program.
If the dishwasher is turned off using the main
power switch or due to a power failure
If the dishwashing program was not finished, the
interrupted program continues when power is
restored.
NOTE!
During drying, the program is interrupted if the power
is cut or the door is open for more than 2 minutes.
8
After dishwashing
Once the program has finished, "End" appears
on the display.
A buzzer also sounds at the end of the program. See
the section Special settings, which describes how to
change this function.
A status light also indicates the end of the program.
See the section Status light.
Once the dishwasher has finished, it uses only
standby power. Turn off the dishwasher using the
main power switch if you want to completely cut the
power. Turn off the water supply valve after each use.
Drying
For additional drying the door should be opened 35
mm upon completion of the drying cycle. For more
information refer to the page marked Performance
information in these instructions.
21
Dishwashing