Asko D5544 XXL FI, Руководство по эксплуатации

Страница: 9 / 24

Blue
Load more. The program has started, but you can still load more
dishes.
Red
Do not load. You should not load more dishes (risk of poorer
dishwashing result).
Flashing red
This indicates a fault. See further in the section Troubleshooting.
Green
Unload. The dishwashing program is finished. Standby light for
two hours.
Stopping or changing a program
If you want to change program after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new program, press Start/Stop and close
the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the program.
If the dishwasher is turned off using
the On/Left-on mode button or due
to a power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
Once the program has finished
Once the program has finished and the door is opened "End"
appears on the display.
A buzzer also sounds at the end of the program. See the section
Settings, which describes how to change this function.
A status light also indicates the end of the program. See the
section Status light™ in the chapter Using the dishwasher.
Once the dishwasher has finished, it uses only standby power.
Turn off the water supply valve after each use.
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
17 in the chapter Technical information.
9