ASKAYNAK MasterSTICK 505, Руководство пользователя

Страница: 22 / 28

Warning !
Before starting the machine following procedures should be performed :
• Provide the necessary environment conditions for the welding machine. For example
there shouldn’t be any flammable gases and vapors, conducting dusts, burner/flammable
fumes and other factors that may be hazardous for insulation and mechanical structure
of the machine.
• Welder has been designed to be used indoors and is not suitable for using under sunlight,
rain and snow.
• Welding machine should be located to a place where can be seen at all times.
• In case of overheating, fume or flame, smell of insulation burn, extreme shocks or extreme
noise, machine should be turned of, mains supply should be disconnected and qualified
electric technician or “ Qualified Technical Service ” should be contacted immediately.
• When current circuit is locked or electric voltage is determined on the body, procedure
indicated in the fourth article should be performed.
• Also in case of mechanical damage such as machine falls down from a high place, again
procedure indicated in the fourth article.
• Extremely damp environment may cause damage to the insulation of the machine and
electric shock danger.
• While operating some internal parts of the machine may get heated and temperature may
increase up to 100°C. This is normal and machine is protected against overheating with
“ Thermal Protection Circuit ”.
• Do not allow extremely high temperatures in cable connection points. If connections
overheated, this is the sign that they are not available to continue working. Parts composing
the connection should be checked and damaged ones should be replaced immediately.
• Bağlantıyı oluşturan parçalar kontrol edilmeli ve hasarlı olanlar mutlaka değiştirilmelidir.
Maintenance and Troubleshooting - 4
Environment Conditions
PROBLEM POSSIBLE REASON
SOLUTION
Sliding core and static core
clearance is asymmetric.
High noise while welding.
More juddering on the
sliding core, loose screw,
path or washer is broken.
For other faults.
Call the authorized service.
Call the authorized service.
Set the path, tighten the screw, replace
faulty parts, bring the movable ferrite core
to the position it was installed before.
56
US
E
R
MAN
U
AL