ASKAYNAK 315-TIG Pulse, Руководство пользователя

Страница: 55 / 78

Preparation for Work - 1
Mains Cable Connection / Controls and Operational Characteristics :
Check the mains voltage, phases and frequency before operating the machine. The mains voltage
to be used is declared in the section “Technical Characteristics” of this manual and on the name-
plate of the machine. Make sure that the cables connecting the machine to the mains are properly
grounded and power supply is sufficient for the normal operation of the machine. The welding
machine must only connected to a 22 A slow-blow (
delay action) fuse protected line with the plug
provided.
1 - 3 s 38 This machine has been designed to operate on phase , 0 V (AC) and 50-60 Hz mains
voltage with insulation based on the line-neutral voltage values. It should be used only in
3- and 4 phase wire systems with earthed neutral.
2 - The machine must not be connected to the mains and turned on without a proper
protective
grounding approved by an authorized electrician. The electrical leaks may be
fatal for the human health.
Duty Cycle and Overheating:
The duty cycle of the machine is the percentage rate of cutting capability of the machine at the
specified welding current to 10 continuous minutes without resulting in overheating or interrupting
the work.
The machine is protected against overheating by the basic protection provided. When this
protection trips, the warning lamp on the panel lights up. When the machine is cooled to the safe
working temperature, the warning lamp goes off and welding is resumed.
Front and Rear Panel Components:
1 - Current and Parameter Display Panel
2 - Welding Current and Parameter Control Knob - Adjusts the output current and welding
parameters of the machine (welding amper config).
3 - TIG Torch Gas Connection Socket
4 - Negative (–) Welding Cable Connection - Welding current negative (–) output connection
5 - Positive (+) Welding Cable Connection - Welding current positive (+) output connection
6 - TIG Torch Trigger Connection Socket
7 - Mode Selection Switch - Coated Electrode (MMA), Gas Test, HF-TIG, LIFT-TIG and 2/4 Trigger
8 - On/Off Switch - Controls the main power input to the machine.
9 - Input Cable - Power cable and plug connecting the machine to the main supply.
10 - Gas Hose Connection Socket
USER
MANU
AL
53