Charging the battery
Fully charge the battery before using it for the first
time. The appliance does not come with a fully char
-
ged battery.
1. Insert the connector into the charging socket.
2. Connect the lead from the charger to a wall outlet.
3. The indicator light flashes to indicate that the
battery is charging.
4. The light indicates by a steady light that the battery
is charged.
Commissioning
Attention! Do not use foaming, corrosive, aggressive,
abrasive or chemical cleaners when using window
and surface cleaners. These could damage the ap
-
pliance.
1. Set the tip of the spray head to the jet (spray) or
spray (water mist).
2. Pour water and a suitable window cleaner into the
spray bottle.
3. Spray the area you want to clean.
4. Pass the microfiber spatula over the sprayed area
and remove any deposited dirt.
5. Switch on the appliance using the on / off switch
(6).
6. Drive the suction nozzle wipe slowly over the wet
surface from top to bottom. The moisture is removed
and sucked into the dirty water tank at the same time.
Warning: Never drive the wiper attachment over a wet
surface from the side. The water would not be sucked
in and would run sideways from the squeegee.
7. After drying one belt, always start from the top.
Note: Only work with the appliance until the dirty
water in the tank reaches the MAX mark. Then switch
off the appliance and empty the tank. Open the cap
under the dirty water tank.
Pour the dirty water out of the tank and close the dirty
water tank again. Then you can continue working.
8. When the entire surface is dry, press the on / off
button again to switch off the appliance. The light
goes out.
9. If necessary, wipe off any tape or moisture residue
on the area to be cleaned with a dry cloth.
CLEANING AND MAINTENANCE
! Disconnect the appliance from the charger before
each cleaning! Otherwise there is a risk of electric
shock!
Do not use any abrasive or aggressive cleaning
agents. These could damage the surface!
Storage when not used for a long time
Do not store the tool in a place where the temperature
is high.
If possible, store the tool in a place with a constant
temperature and humidity.
Specifications:
Operating voltage
3.7V DC 20watt
suction vacuum
1.8KPA
2200mAh
Li-Ion battery
charging time
2.5 h
squeegee width
28cm
operating time
45 min
dirty water tank
60ml
spray bottle with microfiber spatula 280ml
cleaned areas per charge 100m2
IPX4 protection
Cable length
1.2m
Charging unit Prim.
240 V ~ 50 Hz
Sec
DC5 V, 800mA
Weight
0.655 kg
Caution: The vibration level may vary during power
tool operation from the declared value depending on
the way the power tool is used and depending on the
following conditions: Method of power tool use and
type of material being cut or drilled, conditions of the
power tool and method of its maintenance, appro
-
priateness of the used accessories and ensuring its
sharpness and good conditions, the strength of handle
gripping, use of anti-vibration equipment, suitability of
the power tool for the purpose for which it has been
designed and compliance with workflows according to
manufacturer‘s instructions.
If this power tool is used in an inappropriate manner, a
hand/shoulder vibration syndrome may appear.
Caution: For clarification, it is necessary to consider
the level of vibrations in specific conditions of use in all
operating modes, e.g. the time when the power tool is
switched off except for the operation time, and when
it idles, i.e. performs no work. This may substantially
decrease the exposition level during the whole operat
-
ing cycle.
Minimize the risk of vibrations, use sharp chisels, drill
and blades.
44
