Ashley AP5660L, Инструкция по установке и эксплуатации, Страница: 14 / 36

FREESTANDING EXTERIOR VERTICAL INSTALLATION
1. Locate your Pellet Stove Room Heater in a location
which meets the requirements of this manual, but in an
area where it does not interfere with the house framing,
wiring, etc.
2. Install a non-combustible hearth pad underneath the pel-
let stove. This pad should extend at least 6” (152mm) in
front of the unit.
3. Place your Pellet Stove Room Heater on the hearth
pad and locate the unit in a manner that will leave the
exhaust vent with a minimum of 3” (75mm) clearance to
any combustible wall.
4. If installing the optional air intake, locate the center of the
combustion air intake pipe at the back of your unit. Line
up the center with the same spot on your exterior wall
and cut a 2-1/2” (64mm) diameter hole through the wall.
5. Secure all vent joint connections with 3 screws. Seal the
exhaust vent joint connections with high temperature
silicone sealant.
6. Locate the center of the exhaust pipe, at the back of the
unit. Line up the center with the same spot on the exterior
wall a cut a 7” (178mm) diameter hole through the wall.
7. Install the wall thimble; (refer to the instructions which
come with the wall thimble).
8. Install an approved exhaust vent through the wall; be sure
to make sure that 3” (75mm) clearances to combustibles
are maintained.
9. Secure all vent joint connections with 3 screws. Seal the
exhaust vent joint connections with high temperature
silicone sealant.
10. Install a Tee with a cleanout on the end of the exhaust
pipe and then install approved venting upward from there.
Be sure to install support brackets every 5’ (1525cm) to
keep the venting straight and secure.
11. Extend the exhaust vent through the roof fl ashing and
ensure that the vertical cap is approximately 36” (900mm)
above the roof.
Installation
Figure 11
Listed Termination
Flashing
36” (900 mm)
3” (75 mm)
Clearance
6” (150 mm)
Clearance
Wall Thimble
Tee
w/ Cleanout
Support Bracket
6” (150mm)
Non-Combustible
Floor Protection
Existing Combustible
Floor
Combustion Air Intake
with approved cap
14