Ashland Earthmovers I-180TS2, Инструкция по эксплуатации и запасным частям

Страница: 43 / 44

ASHLAND SCRAPERS
Troubleshooting
Introduction
With proper care and maintenance, your Ashland Scraper will give many years of reliable service. When
a situation arises where the earthmover performance is not satisfactory, this section will give some ideas
on finding and correcting the problem. Consult your owners manual for additional troubleshooting help.
Grease zerk will not take grease.
1. Grease zerk plugged.
a) Remove and replace grease zerk.
2. Pin is frozen.
a) Remove, clean, and inspect pin.
b) Replace pin if necessary.
3. Bushing grease passage is not aligned with grease zerk.
a) Remove, clean, inspect, and realign bushing.
b) Replace bushing if necessary and realign.
Push-off rollers do not roll.
1. The rollers need lubrication.
a) Check zerk hole and grease.
b) Remove pin, clean, inspect, and replace if necessary.
2. The roller bushing is worn out.
a) Remove roller assembly and replace bushing.
b) See parts manual.
Cylinders will not hold in preset position, i.e. the cylinder creeps.
1. Seals leaking internally.
a) Remove and replace seal kit.
Machine cuts unevenly.
1. Cutting edges worn unevenly.
a) Replace cutting edges.
2. Improperly inflated tires.
a) Check air pressure in tires
.
PHONE : 715-682-4622 Fax: 715-682-9717
www.ashlandind.com
38