Floor Stand Assembly
Step 8.
Position the loom between the floor stand. Push 2
x 100mm (4”) round head bolts through from the
inside of the loom, through the wooden spacers,
through the top holes in the legs & secure with
large washers & handles. Note the large hole in the
handle must be to the outside. Hammer the bolt
heads into the loom sides rather than tightening
the handles.
Step 9.
Locate the locking peg through a hole in the loom
side & into the stand to prevent the loom rotating.
Locate the leash rod into the leash rod supports &
lock in place.
Step 6.
Locate 2 wooden dowels into the holes in a foot.
Position a leg onto the foot & secure with a 130mm
(5”) bolt, small washer & barrel nut. Note the legs
lean back. Repeat for the other side.
Step 7.
Locate wooden dowels into the 2 outside holes
in both ends of the bottom spacer & then secure
between the legs with 80mm (3 ¼”) hex head
bolts, small washers & barrel nuts.
Leg
80mm hex head bolt
Wooden dowel
Wooden dowel
Foot
Small washer
Small washer
130mm hex head bolt
Back Spacer
Barrel nut
Barrel nut
Attach the Loom to the Floor Stand
Locking peg
Handle
100mm round head bolt
Large washer
Wooden spacer
Leg
Loom side
Small washer
80mm hex head bolt
Barrel nut
Wooden dowel
3
