Ashford Handicrafts Limited
Factory and Showroom: 415 West Street
PO Box 474, Ashburton, 7700 New Zealand
Tel64 3 308 9087
[email protected] www.ashford.co.nz
1. Attach the base rail (with the Ashford logo)
to one side and one foot and secure with a
small washer and knob. Note the tapered side
fits snugly into the tapered rebate in the foot.
Tighten the knobs to make the joint tight.
2. Attached the other side and foot. Secure with a
small washer and knob.
3. Push the 2 bolts through the holes in the side
of the SampleIt loom. Locate the bolts into the
grooves in the top on the loom stand and secure
with large washers and knobs.
4. Sit at the loom with your feet on the base rail.
Loosen the knobs and tilt the loom until it is
resting on your knees. Then re-tighten the knobs.
Now enjoy weaving on your SampleIt loom.
ASSEMBLY INSTRUCTIONS
knob
washer
bolt
base rail
side
foot
