Ashford Handicrafts Limited
Factory and Showroom: 415 West Street
PO Box 474, Ashburton 7700 New Zealand
Telephone 64 3 308 9087 Facsimile 64 3 308 8664
Email: [email protected] Internet: www.ashford.co.nz
Changing the shed
Adjusting the angle
Adjust the angle of the loom
by loosening the back knobs,
slide the bolts along the slots,
then retighten. Check that both
legs are in the same position
to ensure all 4 legs touch the
table.
Reed positions
Rest
(neutral)
position
- use the rest position
of the original reed
support.
Up position
Down position
To change from the down position to the up
position, first lift the back reed rail up, slide
forward and place into the up position.
To change from the up position to the down
position, pull reed slightly forward, tip the
front of the reed down, slide reed back, feed
the top reed rail into the top position and
lower the back reed rail into the back position.
DOWN
UP
UP
DOWN
