11
x
2
b
a
35cm (13¾")
a
b
Place the maiden bar
onto the dowels in the
main upright and secure
with a 50mm (2”) bolt
and barrel
nut.
Insert the end of the flyer
shaft into the rear flyer
bearing and click the
flyer orifice into the front
flyer bearing.
Tie the nylon brake band
to spring . Thread
the nylon brake band
through the eye and tie
spring 35cm (13 ¾”)
from spring , then cut
the surplus nylon off and
tie it to the other end of
spring .
Take the nylon brake
band up and over the
groove in the bobbin and
place spring onto the
hook. Insert the tension
knob into the maiden
bar, thread the end of
the nylon brake band
through the hole in the
tension knob and tie a
knot. Turn the tension
knob to wind on excess
nylon.
Take care not to
over-stretch the
springs.
