4
Foot Switch
If you would like to START and STOP your e-Spinner
Super Jumbo with the foot switch only, insert
the foot switch plug into the FOOT SWITCH hole
under the e-Spinner Super Jumbo. There are two
operating modes.
Foot Switch
Power
NOTE:
ensure the
e-Spinner Super
Jumbo is switched
OFF before
removing the foot
switch plug.
INPUT
Turn the ON/OFF switch to ON.
Lightly put your foot on
the foot switch and turn
the power ON.
Momentary Mode
The e-Spinner Super Jumbo will operate only while your
foot is on the foot switch. Lift your foot off and the
e-Spinner Super Jumbo will stop.
Lightly tap the foot switch to turn the e-Spinner Super
Jumbo ON and lightly tap again to turn it OFF.
(while your foot
is on the foot
switch)
Alternate Mode
SPEED
Start on SLOW
and turn the
dial clockwise to
gradually increase
the speed until
the desired RPM is
reached.
SPIN/PLY
(Clockwise/Anticlockwise)
SPIN is for spinning, PLY
is for plying.
Do not reverse the
direction without
stopping the motor with
the ON/OFF switch.
ON/OFF
The e-Spinner Super Jumbo is fitted with a
soft start which results in the motor taking
2-3 seconds to reach the desired speed. This
prevents the yarn being jerked out of your
hands when starting. When you want to stop
always switch the e-Spinner Super Jumbo OFF
rather than using the speed control. Check
the red LED light is off before you leave your
e-Spinner Super Jumbo.
LED Light
The Red LED light indicates the status of your
e-Spinner Super Jumbo.
Constant On
The e-Spinner Super Jumbo is running normally.
Flashing short on/short off
The e-Spinner Super Jumbo is on standby. The
speed is set to ZERO or the foot switch is OFF.
Flashing long on/short off
The power pack is under load. This is OK, and
you can’t harm the e-Spinner Super Jumbo.
However, we recommend you apply a drop of
oil under the leather brake band and to the
flyer and bobbin bearings, reduce the leather
brake band tension and reduce speed until the
flashing stops.
Control Panel
Controls
IMPORTANT:
Avoid tripping over or yanking on the foot switch
or power pack cords as this can damage or break the plugs
and void your warranty. Please remove both cords when
transporting your e-Spinner Super Jumbo.
