ASG, Division of Jergens, Inc.
15700
S. Waterloo Road | Cleveland, OH 44110-3898 | Phone: (888) 486-6163 | Fax: (216) 481-4519 | Email: [email protected] | www.asg-jergens.com
Page 9 of 15
While operating the tester, it may be necessary to zero the display so that residual torque does not become part of the measured
reading. Press and release the
ZERO
key.
You can choose from the following modes of measure:
Track, First Peak,
and
Peak
. To change the display mode, press the
MODE
key. Each time the
MODE
key is pressed, it will select the next available mode until the tester returns to its original setting.
You can choose from the following units of measure depending on the capacity of your tester: N.mm (not available on the DTT-L 500),
N.cm, N.m, kgf.cm, kgf.m, lbf.in, and lbf.ft. To change the display units, press the
UNIT
key. Each time the
UNIT
key is pressed, it will
select the next available unit until the tester returns to its original setting. The DTT-L automatically converts readings as new units of
measure are selected.
NOTE:
All units may not be displayed depending on tester capacity.
Basic Function (Continued)
Zeroing the Tester
Changing the Mode of Measure
Changing the Unit of Measure
Press the
MODE
key until “Track” appears on
the display. The display will now indicate the
torque applied in either direction as it is applied
to the transducer.
Press the
MODE
key until “Peak” appears on
the display. The display will show the maximum
torque applied to the
transducer during a cycle.
Press the
MODE
key until “FPeak” appears on
the display. The display will show the torque
level applied to the transducer.
Track Mode
Peak
Mode
First Peak Mode
DTT-L Series Digital Torque Testers
User Manual
