5.
FUSES LOCATED IN
VOLTAGE SELECTOR
MODULE
Carefully reinstall fuses into Fuse Holder and slide
Holder back into Selector Module (Figure 1e). Apply
pressure until locking tab snaps back into position,
producing a distinct clicking sound.
3. Mount the clip-on Holder to the extended handle of
the Case, as shown in Figure 3.
Fig. 3
Clip-On
Holder
Handle
Saliva
Ejector
3-Way
Syringe
Handpieces
HVE
4. Attach a sterile handpiece to the ISO Type B (4-Line)
handpiece connector and place the handpiece in
Holder (Fig. 3).
5. Remove the 3-way air/water Syringe from its travel
clip inside the Case and place it in the Holder.
6. Position the Waste Tank in the Case with the large
white connection to the rear left of the instrument
as shown in Figure 4. Attach the hose connector
coming from the Vacuum Motor to this large white
connection. Connect the High Volume Vacuum
(HVE) hose to the large gray connector located
on the front of the Waste Tank. Connect the Low
Volume Vacuum (Saliva Ejector) hose to the black
connector located on the front of the Tank.
Note:
When attaching the Saliva Ejector hose to the
top of the Waste Tank, push in and rotate 1/4 turn
(see Figure 5).
7. Secure Waste Tank by running Bungee Cord from
hooks on bottom panel overtop Tank lid. Verify that
the Waste Tank and vacuum lines are properly
installed. Hang the High Vacuum and Saliva Ejector
instruments on the Clip-On Holder.
8. Fill the Water Supply Bottle with clean water and
connect to the Water Reservoir Connector.
9.
Attach the foot pedal and place on the floor.
Voltage Selector Module
Fig. 2a
Fig. 2b
Fig. 2c
Fig. 2d
Fig. 2e
120V Indicator
240V Indicator