P/N 420284-01
Rev. D
ECO 14684
03/2019
Printed In The USA
P.O. Box 1548 • Woodinville, WA 98072
8333 216
th
Street S.E. • Woodinville, WA 98072
International (425) 487-3157 • Toll Free(800) 426-5913
www.aseptico.com • [email protected]
WARRANTY
Aseptico warrants its products against defects in material or workmanship for a period of two (2) years, from
date of original invoice. Some handpieces are warranted for one year under the same conditions. Other
handpieces and expendable components, such as air turbines and light bulbs, are covered by shorter
warranty periods, or have no warranty. Aseptico's sole obligation under product warranty is (at its sole option
and discretion) to repair or replace any defective component or product in part or whole. Aseptico shall be the
sole arbiter of such action.
In the event of alleged defect under warranty, the purchaser is to notify Aseptico's Customer Service
Department promptly. Customer Service will provide instructions, usually directing that the product be
returned for service. Shipment to Aseptico and the cost thereof is always the responsibility of the purchaser.
Accidental misuse, inappropriate installation, or failure to perform directed maintenance voids the warranty.
Deliberately defacing, modifying, or removing the serial number voids the warranty.
Aseptico does not assume, under this warranty, any risks or liabilities arising from the clinical use of its
products, whether or not such use involves coincidental utilization of products manufactured by others.
CLEANING
Syringe Tip Sterilization:
1)
Remove contaminated syringe tip.
2)
Remove all visible signs of contamination
before autoclaving.
3)
Autoclave tip at 132° C (270° F) for ten minutes.
4)
Sterilize between each patient use.
NOTE
: Since only the tips can be autoclaved,
it is recommended that the air/water syringe
be bagged with a disposable, single-use
plastic sleeve between each patient use.
Saliva Ejector:
The valve assembly on the
saliva ejector snaps apart at the swivel. After
each use, the vacuum system should be
cleaned by running clean water or vacuum
system cleanser through the evacuator hose.
HVE System:
After each use, the high volume
evacuator system should be cleaned by
running clean water or a vacuum system
cleanser through the evacuator hose.
Vacuum System Waste Bottles:
Waste from
the vacuum systems will collect in their
respective plastic waste bottles. When the
waste containers are 3/4 full, they should be
emptied. After each use, the vacuum systems
should be cleaned by running clean water or
a vacuum system cleanser through the
evacuator hoses.
CAUTION
: Use only NON-
foaming cleansers in the vaccum
lines.Thoroughly clean the waste bottles.
Water Lines-
Disinfect the water lines weekly.
Prepare a 1:10 bleach solution (1 part
household bleach to 10 parts water). Remove
water reservoir and discard residual water.
Replace empty water supply tank and air
purge all waterlines. Fill water supply tank
with bleach solution. Run bleach solution
through all lines. Allow bleach solution to
stand in lines for 10 minutes. Remove water
supply tank and discard bleach. Flush water
supply tank and all lines thoroughly with clean
water. Air purge and leave lines dry until next
clinical use.