Version: V1.0 Apr 28th,2018
4
ASENWARE LTD
ADDRESS: 6 PROSPECT WAY, ROYAL OAK INDUSTRIAL ESTATE DAVENTRY,
NORTHAMPTONSHIRE, ENGLAND, NN118PL
WEBSITE: www.asenware.com
EMAIL: [email protected]
VI. Installation and debugging
Determine the location, mounting distance and numbers for mounting the detectors in the protection area
according to relevant provisions and regulations of the local codes.
A self-contained complete base is necessary during the installation of a detector. As shown in Fig.6, the
model, the external dimensions, the mounting hole diameter and the mounting hole spacing of the base
are DZ-912, 100mm
×
26.4mm (diameter
×
thickness), 4.5mm and 44.5mm
～
64.3mm respectively.
Fig.6(unit:mm)
Wiring requirement:
It is proper to use RVS twisted pairs with a section area of equal to or larger than 1.0mm
2
for the signal
buses L1 and L2.
Specific installation and debugging methods:
1.
Make sure the type of the detector matches the type of the host machine of the fire alarm control
panel;
2.
Use two M4 screws to fix the matched mounting base on the designated position via the
mounting holes A and B shown in Fig.6 as instructed in the construction drawing and make sure
the matched mounting base has been firmly installed.
3.
Use a coder to make the detector coded according to the detector address on the construction
drawing.
4.
Disconnect the power supply of the fire alarm control panel and connect the detector correctly
according to the construction drawing.
5.
The lower edge of the detector base raised position aligned with the groove position, and then
the detector into the base, the detector clockwise until it locks into place the detector.
6.
After all the products are installed and checked, connect the power supply of the fire alarm control
panel and conduct automatic login.
7.
when automatic login is success, the red indicator of the detector will blink once about every 12
seconds, which suggests that the detector has begun to operate normally.
8.
Finally conduct an alarm test for the detector through some special tools or direct hot air gun
blowing. After the detector gives a fire alarm, the indicator will remain lit and the fire alarm control
panel will simultaneously give corresponding alarm prompt information. After the alarm test, reset
the fire alarm control panel and restore to the monitoring status.
