ASEKO s.r.o.,
Vídeňská 340, 25242 Vestec u Prahy
Phone 244 912 210
Fax 244 910 800
http://www.aseko.cz
The operating life of the electrodes
The electrodes are made of titanium coated with a special layer of ruthenium and iridium. During the electrolysis
this layer is consumed. In order their decrese was minimal, you should avoid
Low content of salt (under 4 g/l)
Water temperature below 10°C
Low water flow
Too hard water
The pH level under 7.5
Addition of chemicals containing metals
Cleaning of the electrodes
During the operation the electrodes are gradually polluted by deposits from hard water which must be perodically
removed. The clogging of the electrodes causes the output decrease, i.e. at unchanged salt content the output
decreases (observed on the display on the fromt panel). In this case the system must be switched off, electrodes
taken out and for about 10 minutes plunged into the solution for the electrodes cleaning. The whity coating should
disappear and the electrodes can be returned back.
Maintenance
Neither ASIN Salt 2 nor the electrolyzer TE13 require any maintenance. However, both device are situated in a
corrosive environment and therefore it is necessary to check, eventually clean the elctric connections.
The electrolyzer must be kept in the temperare above zero,
water inside may in no case freeze!
Ocupational safety
ASIN Salt 2 may operate persons without electronic qualification.
Removing covers and exchanging any of the
machine’s parts is forbidden. To clean the machine, use a cloth
dampened with water or detergent. Use ethyl alcohol to remove stubborn stains. The use of other organic solvents
is forbidden, as well as the use of any cleaners that would cause abrasion of the surface of the plastic case or the
front cover.
Persons working with ASIN Salt 2 must be informed that using the machine in a manner not intended by its
manufacturer can render ineffective the electrical safety features of the device.
Guarantee
The manufacturer is liable for defects of the ASIN Salt 2 equipment and electrolytic cell for 2 years from the date of
sale. If this date is not credibly evidenced, the guarantee period starts on the production date indicated on the pro-
duction label.
The manufacturer is not liable for defects caused by the operation of ASIN Salt 2 in contradiction with the manual
as well as for defects caused by inexpert installation of the equipment.
Before you call a maintenance technician to exercise the guarantee check the following point that are within the
scope of your responsibility.
The power supply is functional
The equipment is installed in accordance with the manual
Water has the correct pH parameters and content of salt
The electrolytic cell is clean
There is a sufficient water flow through the electrolytic cell
The fuse of the device is OK.
!!! WARNING !!!
All of the chemicals used for water quality treatment are caustic. Do not allow them to come in contact with
your skin! Wear rubber gloves and work with all due care when refilling chemical supplies and when
changing pump tubes. Stains on clothing from these substances will cause irreparable damage! Always
obey the safety instructions for the individual chemicals (see the safety sheets) when handling them or
Содержание ASIN Salt 2
Страница 1: ...ASIN Salt 2 User s manual...
